Sewer and Drain Jetting in Tampa, FL

Anthony Gennaro Plumbings’ pressure sewer jetting method of cleaning sewer and drain lines using high-pressure water. An engine or other power source powers a high pressure water pump that produces water under pressure. All high pressure jetting units are rated as to pressure (PSI) and water flow (GPM); both a direct result of the available diesel engine’s horsepower.

Water from the high pressure pump is delivered to a hose reel containing high pressure jetting hose matched for the pressure and flow of the system. When a nozzle is attached to the end of the jetting hose, pressure is created within the system. Nozzles are sized to match the design out of the engine and water pump plus factoring pressure loss due to the diameter and length of the high-pressure hose. Every nozzle is designed to direct high-pressure streams of water to pull the high-pressure jetting hose through a pipe. Angles of water stream can be varied; water streams directed more toward the pipe wall surfaces produce better cleaning results while diminishing the pulling power of the nozzle. Water streams directed towards the centerline of the pipe provide maximum pulling power but decreases pipe wall cleaning effectiveness. 

Clearing Clogged Sewer Lines

To clear a clogged sewer line, a nozzle with a forward jet(s) is used. Forward jet(s) only use a small proportion of the total GPM to bore through a blockage with a minimal loss of propulsion. The forward jet is designed to bore into the blockage to allow the rear jets with more flow to remove the bulk or remainder of the blockage. Note that a forward jet(s) may have reduced flow per orifice compared to the rear nozzle orifices; the pressure (PSI) is always the same at all orifices.

Anthony Gennaro Plumbing services Tampa and all of Central Florida.